Oki IP-5630, User Manual, Page: 170 / 265

170
Advanced operations
Suspend printing when media wrinkles are detected
To prevent the printouts to be soiled due to the print heads touching the media, this function can suspend printing
when contact between the print heads and the media is detected. Select the mode according to the characteristics
of the media used.
STOP PRINTING
(default setting)
Printing is stopped immediately if a contact between the print heads and the media is
detected.
The printing interruption is notified by a warning sound and a message displayed on the
panel.
Printing cannot be resumed after it has been stopped, so it is required to perform printing
again after reloading the media.
SUSPEND PRINTING Printing is suspended temporarily and the print heads are capped if a contact between
the print heads and the media is detected.
The printing temporary suspension is notified by a warning sound and a message
displayed on the panel.
Printing can be resumed after checking the media conditions and removing the wrinkles,
if any.
SUSPEND&WARNING
Printing is suspended temporarily and the print heads are capped if five contacts between
the media and the print heads are detected consecutively.
Any contact detected between the media and the print heads is notified by a warning
sound and a message displayed on the panel.
Printing suspension is also notified by a warning sound and a message displayed on the
panel.
Printing can be resumed after checking the media conditions and removing the wrinkles,
if any.
WARNING ONLY Printing continues even when contacts between the media and the print heads are
detected.
However, any contact detected between the media and the print heads is notified by a
warning sound and a message displayed on the panel.
The warning sound stops and the panel message disappears when contact is not
detected anymore.
Printing can be suspended manually and resumed after all wrinkles have been removed.
Notes
Pay attention to the following when Safe Scanning is set to STOP PRINTING.
‹
When the printing has been stopped, load the media again without delay to prevent the print heads from drying.
Pay attention to the following when Safe Scanning is set to WARNING ONLY.
‹
The print heads may be damaged if printing is performed during a long time while the warning indicating that the print
heads contact the media is emitted.
Pay attention to the following when Safe Scanning is set to SUSPEND PRINTING or SUSPEND&WARNING.
‹
Make sure that all the wrinkles have been removed when resuming the printing after it has been suspended.
‹
If missing dots appear on the printout after resuming the printing, pause printing and perform PH Recovery.
1
PRINTER READY
01: PAPER / 1626mm
Press the MENU button.