Oki IP-5530, User Manual, Page: 65 / 265

65
Loading the media
Cutting the media
This section describes the cutting procedure using the optional cutter unit (64) (cutter unit (54) for the IP-5530)
1
Clip both ends of the media with the media
clip.
2
Move the media cutter blade and cut the
media.
Arrow mark
š
The arrow mark (
g
) is engraved on the media cutter
blade.
The media cutter blade can only cut in the direction
of the arrow mark (
g
). If the arrow mark (
g
) is
not oriented in the cutting direction, change the
orientation with the procedure below.
3
1
Hold the side of the media cutter blade
and pull it out while releasing the
hooks.
2
Invert the media cutter blade so that
the left side comes to the right side and
then install it.
Note
‹
If the media cutter gets stuck while cutting, return the cutter blade to the side, remove curls and other causes of the
problem, and cut the media by slowly moving the media cutter blade. Do not forcibly cut a media. Doing so may damage
the blade and cutting performance may be degraded.
‹
If you drop the media cutter blade, the blade may be damaged, resulting in poor cutting performance. Handle it with
care.
‹
The media cutter blade may not be able to cut thicker media. In this case, use a pair of scissors. Forcibly cutting thicker
media may damage the media cutter blade and degrade cutting performance.
Be
fo
re
p
rin
tin
g
Lo
adi
ng
the
m
edi
a
A
dj
us
tm
ent
M
ai
nt
enan
ce
A
dv
an
ce
d
op
er
ati
on
s
Trou
ble
sh
oo
tin
g
M
enu
tr
ee
Ap
pe
nd
ix