Oki ES9455, Software Setup Manual

Page: 165 / 386

8.[Administration] Tab Page
[Setup] Item List 163
8 [Administration] Tab Page
‰ Setting up SMTP Client
In SMTP Client, you can enable or disable SMTP transmission for sending the Internet Fax and E-mails.
A From Address setting is also required to send Internet Fax and E-mails. For information about the From Address
setting, see the following sections:
P.236 “Setting up E-mail settings”
P.238 “Setting up InternetFax settings”
The From Address can be also determined automatically when the User Management Setting is enabled. For more
information about User Management Setting, see the following section:
P.139 “[Administration] Tab Page”
Item name Description
1 Enable SMTP Client When this is enabled, this equipment sends an Internet Fax and an E-mail to the specified
SMTP server for transmission over the Internet. [Enable] is set as the default.
2 Enable SSL Select whether the SSL (Secure Sockets Layer) is enabled or disabled for SMTP
transmission.
y Disable — Select this to disable the SSL for SMTP transmission.
y Verify with imported CA certification(s) — Select this to enable the SSL using the
imported CA certificate.
y Accept all certificates without CA — Select this to enable the SSL without using
imported CA certificate.
y When [Verify with imported CA certification(s)] is selected, you must import the CA certificate in this equipment.
P.275 “[Security] How to Set and How to Operate”
y Not all operating systems support SSL for all protocols.
3 SSL/TLS Select the protocol for the SSL when the [Enable SSL] option is enabled.
y STARTTLS — Select this to send a message in TLS (Transport Layer Security) using
STARTTLS that is the extension command for SMTP transmission.
y Over SSL — Select this to send a message in SSL (Secure Socket Layer).
When you select [Over SSL], make sure to change the port number correctly. Generally, "465" port is used for the Over SSL
instead of "25" port.
4 SMTP Server Address Enter the IP address or FQDN (Fully Qualified Domain Name) of the SMTP server when
[Enable SMTP Client] is enabled. You can enter up to 128 alphanumerical characters and
symbols other than =, ; (semicolon), #, and \ (backslash).
If you use FQDN to specify the SMTP server, you must configure the DNS server and enable the DNS in the DNS Session.
When the [Obtain a SMTP Server Address automatically] option is enabled in the TCP/IP settings, the SMTP server address
can be obtained using the DHCP server.
P.148 “Setting up TCP/IP”
1
2
3
4
5
6
7
8
9
10
11