Oki ES7170dnf, Basic Manual

Page: 43 / 94

1
2
3
4
5
6
BASIC COPY MODES
- 43 -
●
BASIC COPY MODES
Before Using Copying Functions
Default settings
This equipment is under its “default settings” when the power is
turned ON, namely, if no setting change has been applied yet,
the equipment’s settings return to the default ones when the
energy saving mode is cleared or the [RESET] button on the
control panel is pressed. The default settings for basic copy
modes at installation are shown below.
The default settings are changeable.
Confirming the set functions
If you press [SETTINGS] on the touch panel, the menu shown
below is displayed. On this menu, you can view the functions
that are currently set.
Switching to the function setting menu
To change the functions on the current menu, press the
corresponding buttons. The desired setting menu will then
appear.
Clearing the set functions
If you want to clear any copy function setting, press [RESET]
on the corresponding setting menu.
Clearing all settings changed
When you press the [RESET] button on the control panel, all
the function changes will be cleared.
Even if you do not do so, the changes will be cleared if the
equipment is left idle for 45 sec. (default setting).
Restrictions on function combinations
Several copy functions can be used together. However some
functions may not be used with other ones. For details, see the
following Guide:
 Advanced Guide
Item Default setting
Reproduction ratio 100%
Copy quantity 1
Paper selection Automatic Paper Selection
(APS)
Simplex/Duplex 1-sided original -> 1-sided copy
Density adjustment Automatic adjustment
Original mode TEXT/PHOTO
Finishing mode When using the original glass:
NON-SORT NON-STAPLE
When using the RADF
(Reversing Automatic Document
Feeder):
SORT
Feeding mode when using the
RADF Continuous feed mode