5
5-138 Setting up the Fiery from a Windows Computer
ES3640e MFP EFI Configuration Guide - 138
Outgoing Mail Server
—Specify the IP address or server name that
communicates the appropriate mail server and contact
information to the Fiery.
Note:
You must define both an Incoming and Outgoing mail server.
If an Outgoing mail server is not defined, the E-mail Service
assumes that the incoming and outgoing server names are the
same.
Timeout (seconds)
—Specify the maximum amount of time that
will elapse as the Fiery attempts to connect to the mail server.
Polling Interval
—Specify how often the Fiery checks the mail
server for relevant e-mail.
Mailbox Account Name
—Enter the mailbox name specified on the
mail server. This name tells the Fiery client mail service which
account contains e-mail messages for the Fiery.
Note:
The account name entered in this field must first be
specified on the mail server by the administrator.
Fiery E-mail Address
—Enter the name of the e-mail account. For
example, [email protected].
Password
—Enter a password for accessing the mailbox account
on the mail server.
Verify Password (remote Setup only)
—Reenter your password.
Administrator E-mail Address
—Enter the address specified in
Fiery setup.
The administrator authorizes a unique e-mail address to remotely
administer e-mail services. If an error occurs while you are
sending a job via e-mail, E-mail Service sends an error message
to the Administrator E-mail Address specified. The administrator
can authorize additional administrator e-mail addresses from this
e-mail address.
Printer Setup options
From this dialog box, you can access the Printer Setup and Paper
