Oki Dr.63514, User Manual, Page: 93 / 101

Appendices
A-6
4. Probe Cable Connectors and Pin Layout
The probe connector on left side of the emulator is for the probe cable.
1 pin
16 pin
15 pin
2 pin
Polar key side
The 16-pin connector shown in the figure at the left is
the probe connector. Pin 1 is at the upper right.
Figure A-3 Probe connector layout
Table A-2 Probe connector pin list
Pin number Probe color Name Pin number Probe color Name
1 Black PROBE0 9 Yellow SYNC.OUT
2 - VSS 10 - VSS
3 Brown PROBE1 11 Green EXT.BRK
4 - VSS 12 - VSS
5 Red PROBE2 13 Blue VSS
6 - VSS 14 - VSS
7 Orange PROBE3 15 Purple VSS
8 - VSS 16 - VSS
n
Note 1
n
________________________________________________________________________________________________________________
(1) PROBE0 to PROBE3 are for tracing external signals.
(2) SYNC.OUT produces a pulse each time that the emulator executes the instruction
at an address with its sync out bit set to “1.”
(3) EXT.BRK is an external break signal.
________________________________________________________________________________________________________________________________