Chapter 3. Setting Up and Starting Up
3-7
1.4 Powering Up
First make sure that
•
the emulator is connected to the host computer,
•
the emulator switches have been properly set,
•
the emulator is connected to the user application system.
Follow the procedure below to start the emulator.
(1) Emulation mode
1. Load the dedicated debugger.
2. Turn on the power to the emulator.
3. Wait for the emulator's POWER LED to light.
4. Turn on the power to the user application system.
(2) Evaluation mode
1. Turn on the power to the emulator.
2. Wait for the emulator's POWER LED to light.
3. Wait for the emulator's RUN LED to light.
4. Turn on the power to the user application system.
5. Press the reset switch on the user application system.
Caution
Pay close attention to the sequence of applying power, or
you could damage the emulator.
(1) When turning power on:
a. Turn on power to the emulator.
b. Turn on power to the user application system.
(2) When turning power off
a. Turn off power to the user application system.
b. Turn off power to the emulator.
Summary of Contents for Dr.63514
