Oki C9800hdn, Software Installation Manual

Page: 31 / 104

1
1-17 Setting up PostScript or PCL printing with Windows NT 4.0
Setting up PostScript or PCL printing with
Windows NT 4.0
To set up the Fiery as a PostScript or PCL printer, you must install the PostScript or
PCL printer driver for Windows NT 4.0 and the corresponding printer description
files. You must also configure the print connection between the computer and the
Fiery. If you are printing over a network, you must configure a network connection. If
you are printing directly to the printer, you must configure a parallel port connection.
N
OTE
:
The procedures for setting up printing with the PostScript and PCL printer
drivers are similar. The following illustrations show the PostScript driver. Any
differences are noted.
Installing the PostScript or PCL printer driver
for Windows NT 4.0
The procedure for installing the printer driver(s) for Windows NT 4.0 is similar to
that for installing under Windows 98. If you follow that procedure, installing from the
included Drivers CD (CD1), the LPR and Network Extension utilities are
automatically included in the installation, and the network connection on TCP/IP
networks is established automatically by the installer.
T
O INSTALL THE
P
OST
S
CRIPT OR
PCL
PRINTER DRIVER
FOR
W
INDOWS
NT 4.0
1. Insert CD1 into your CD drive and wait for the CD to autorun the setup program.
If the CD does not autorun navigate to the CD root directory and double-click the
setup.exe program to start the installer.
2. Choose your preferred language for the installer from the drop-down list.