Oki C9800hdn, Configuration Manual, Page: 63 / 168

4
4-11 Network Setup options
When you set an IP address, subnet mask, or gateway address for the Fiery during
Setup, you can allow the Fiery to get these addresses automatically from a DHCP or
BOOTP server. First, turn on or restart the Fiery and allow it to reach Idle. Make sure
the DHCP or BOOTP server is running, and then perform Fiery
Setup.
TCP/IP Setup with Ethernet
Enable Auto IP Configuration
Yes/No [Yes]
Select Yes to allow the Fiery to obtain its Ethernet IP address by searching the network.
Depending on your network and the protocol you select in the following option
(DHCP or BOOTP), the IP address can change. Select No to assign the Fiery a static
IP address. If you select No, you proceed to the IP Address option, where you manu-
ally set the IP address.
Select protocol
DHCP/BOOTP [DHCP]
This option appears only if you answered Yes to Enable Auto IP Configuration. Select
the protocol over which the Fiery should search for its IP address. Both DHCP and
BOOTP allow the Fiery to obtain the Ethernet IP address and Subnet
Mask
automatically.
Depending on your network, the Fiery might be assigned a different address after you
restart the Fiery. With the DHCP setting, the Fiery can be assigned a different address
even if it is not restarted. Make sure the network is already configured properly for the
protocol you select.
Network Setup
Protocol Setup
TCP/IP Setup
Ethernet Setup
Enable TCP/IP for Ethernet
Yes/No [Yes]
Select Yes if you have a TCP/IP network connected to the printer over
Ethernet
cabling.
N
OTE
:
If you are using TCP/IP for printing from Windows computers, enabling
TCP/IP here also enables you to use Fiery utilities from Windows computers using
TCP/IP protocols.