Oki C9800hdn, Configuration Manual, Page: 62 / 168

4
4-10 Performing Setup from the Control Panel
Ignore EOF Character
Yes/No [Yes]
This option appears only if Enable Parallel Port is set to Yes. This option specifies that
the Fiery should ignore end-of-file (EOF) messages in a file. This option must be set to
Yes to print PostScript files in binary format (not ASCII); under normal circumstances,
it should be set to No. When this option is set to Yes, the Fiery uses the parallel port
timeout value to determine when the end of the file has been reached. If you experi-
ence printing problems, set this option to No.
Protocol Setup options
AppleTalk Zone
List of zones
The Fiery searches the network for AppleTalk zones in your network segment. Scroll
through the list to select the AppleTalk zone in which you want the Fiery to appear.
If your segment has only one zone, the Fiery is assigned to that zone
automatically.
The message “No AppleTalk zone found” may mean your network has no zones, or the
network cable is not connected (see
Appendix A ).
TCP/IP Setup options
To configure the Fiery, choose each protocol and enter the settings for that
protocol. You can enable AppleTalk, TCP/IP, and IPX/SPX communication
simultaneously.
Network Setup
Protocol Setup
AppleTalk Setup
Enable AppleTalk
Yes/No [Yes]
Select Yes if you have an AppleTalk network connected to the Fiery. This setting
enables the Fiery to communicate over AppleTalk networks.
To configure the Fiery for TCP/IP, choose TCP/IP Setup.
Choose Ethernet Setup and enter the appropriate settings. Choose each network
type you use (Ethernet) and enter the appropriate settings.