- 20 -
Preparing Your Printer
1
1.
Setup
5
Load paper with the print side face down
and press it from above.
Note
●
Do not load paper exceeding the [ ] mark (5) of the
paper guide.
5
6
Secure the loaded paper with the paper
guide.
7
Check if a size of loaded paper matches
the setting of paper size dial.
8
Return the paper tray to the printer.
Memo
●
If loading a paper that you cannot select the
size with a paper size dial options, set the dial to
[
Other
], and then set a paper size on the operator
panel.
Turning On/Off the Power
Power Supply Conditions
The power supply must meet the following
conditions:
Voltage:
110 - 127 VAC (Range 99 - 140 VAC)
220 - 240 VAC (Range 198 - 264 VAC)
Frequency: 50/60 Hz ± 2%
Note
●
If the power supply is unstable, use a voltage regulator.
●
The maximum power consumption of this printer is
1400 W. Ensure that the power supply is sufficient to
operate this printer.
●
We do not guarantee operation where an uninterruptible
power system (UPS) or inverter is used. Do not use an
uninterruptible power system (UPS) or inverter.
WARNING
There is a risk of getting
an electric shock and/or
causing fire.
●
Be sure to turn off the power supply switch when
attaching or removing the AC cable and earth wire.
●
Be sure to connect an earth wire to the grounding
terminal of exclusive use.
●
Please do not connect with the ground of a water pipe,
a gas pipe, and a telephone wire, and a lightning rod by
any means.
●
Make sure to connect with the ground terminal before
connecting the power cord to the power supply plug.
●
Be sure to plug in and unplug the AC cable while holding
on to the power supply plug.
●
Insert the AC cable plug completely into the wall socket
securely.
●
Do not touch the power cord, or printer, if your hands
are wet.
●
Install a power cord in the place which is not stepped
on, and do not place a thing on a power cord.
●
Do not use the cord tied in a bundle.
●
Please do not use the damaged power cord.
●
Do not use multi-outlet adapters.
●
Do not connect this printer and other electric products
to the same wall socket. If it connects simultaneously
with an air conditioner, copier, shredder, etc. Especially,
a printer may incorrect-operate by the electric
noise. When you connect with the same wall socket
unavoidably, please use a commercial noise filter or a
commercial noise cut transformer.
●
Use the attached power cord and insert it directory with
the ground terminal. Do not use the power cord for
other product for the printer.
●
Do not use an extension cord. When you use it
unavoidably, use the thing more than rated 15 A.
●
Use of an extended code may not operate a printer
normally by AC voltage descent.
●
During printing, do not shut off a power supply or do not
pull out a power supply plug.
●
When you use it neither for consecutive holidays nor a
travel for a long time, pull out a power cord.
●
Do not use attached power cord to the other products.