Oki Data CONFIDENTIAL
43827101TH Rev.2
208 /
(6-2)Paper exit jam occurs right after feeding paper
Face-up stacker cover
Duplex pull-in gate
Rear panel
Running route in delivery
section
Sensor lever of exit sensor
Fuser motor
Confirmation Tasks
Check to see if the cover is completely open or closed.
Conduct the Motor and Clutch Test of the self-diagnostic mode,
and check to see if the Duplex pull-in gate operates normally.
Make sure that it is duly on the exit side.
Check to see if the rear panel is installed properly, and if it is not
obstructing the paper running route.
Check visually for any load that obstructs running of paper along
the route of the delivery section.Check to see if the delivery
rollers are stiff in rotating.
Check to see if the sensor lever demonstrates any abnormal
shape or motion.
Conduct the Motor and Clutch Test of the self-diagnostic mode,
and check to see if the fuser motor operates normally.
Make this checking in the presence and absence of a load.
Action at NG
Eliminate imperfect
opening or closing of
the cover.
Replace the duplex
pull-in gate or replace
the duplex solenoid.
Redo the installation of
the rear panel.
Modify the load portion.
Replace the sensor
lever with a normal
one.
Replace the PU PCB,
fuser motor, or fuser
unit. To use a new
fuser unit on a trial
basis, use FUSE KEEP
MODE of the System
Maintenance Menu.
(6-2-3) Check of operating state of motor
(6-2-1) Check of state of running route
(6-2-2) Check of state of mechanical parts
Confirmation Items