42049001TH Rev.1
34 /
Oki Data CONFIDENTIAL
2.2.18 Main Motors / Solenoid / Paper-End Sensor
(1) Remove the left side cover, the right side cover, the rear side cover, the top cover unit and the
feeder unt (see sections 2.2.2 , 2.2.3, 2.2.5, 2.2.9 and 2.2.17).
(2) Remove the print engine controller PWB, the controller PWB and the film [see sections 2.2.7,
2.2.8 and 2.2.12 (3)].
(3) Remove the fan (ID), the frame duct, the fan (Pow L) and the low voltage power unit (see
section 2.2.12).
(4) Remove the plate-heat, the eject assy, the cover-driver, the color-registration assy and the
board-RSM (see section 2.2.14).
(5) Unscrew the two screws
1
to remove the plate-driver
2
.
(6) Disengage the latch to remove the cover-hopping
3
.
(7) Remove the fan (fuser) and the image drum up/down sensor
4
(see section 2.2.15).
(8) Disengage the latch to remove the gear assy - planet
5
, the shaft
6
and the three rollers
7
.
(9) Unscrew the two screws
8
to remove the side plate R assy
9
.
(10) Remove the two screws
0
and the two E rings
A
, then remove the plate-outer
B
, the gear-idle
K
C
, and Y and C
D
, and M
E
.
(11) Unscrew the three screws
F
to remove the plate-inner
G
.
(12) Remove the screws
H
(one screws each motor-ID
I
) and the connectors, then uninstall the
motors-ID
I
.
(13) Remove the screw
J
to remove the gear assy - hopping
K
.
(14) Remove the screw
L
to uninstall the solenoid
M
.
(15) Remove the spring
N
, disengage the claw and remove the bushing
O
, the hopping roller shaft
P
and the frame-hopping
Q
.
(16) Detach the paper-end sensor
R
and the paper-end lever
S
.
www.eManualpro.com