Transfer Belt
Installation Instructions
Caution!
The fuser is very HOT after the
printer has been printing. For your
safety, let the printer cool down at
least 10 minutes before attempting
to replace the transfer belt.
To replace the belt unit:
1. Turn off the printer.
Note:
If the hard disk drive is installed in
your printer, press the SHUTDOWN/
RESTART button for several seconds
before turning the printer off.
2. Open the top cover.
Caution!
The fuser is very HOT after the
printer has been printing. Be
careful not to touch it!
3. Remove the four image drums/toner cartridge
units and place them on a flat surface.
4. Cover them with dark paper or plastic to
protect them from light.
5. Lift the transfer belt latches to release them.
© 2009 Oki Data Americas, Inc.
58396901
