5: English
Regulatory Information
Year 2000 Compliance
This product is Year 2000 Compliant. It contains information
technology that accurately processes date and time data
between the years 1999 and 2000, and carries no issue for the
September 9, 1999 (9999) programming concern. This
product, when used in combination with products purchased
from other manufacturers, whose products properly exchange
data and time information, will accurately process the date and
time.
Federal Communications Commission
(FCC)
FCC Declarations of Conformity for 120V Models
1. Product Identification
Product Name: B4545 MFP
Model No.: B4545
2. Statement
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this
device must accept any interference received, including
interference that may cause undesired operation.
3. Responsible Party
Oki Data Americas, Inc.
2000 Bishops Gate Boulevard
Mt. Laurel, NJ 08054-4620
1-800-654-3282 (1-800-OKI-DATA)
FCC Requirements for End Users
This device has been granted a registration number by the
Federal Communications Commission, under Part 68 rules and
regulations for direct connection to the telephone lines. In
order to comply with these FCC rules, the following instructions
must be carefully read and applicable portions followed
completely.
1. This equipment complies with Part 68 of FCC rules adopted
by th ACTA. On the back of the equipment is a label that
contains, among other information, a product identifier in
the format US:AAAEQ##TXXXX. If requested, this
information must be provided to the telephone company.
2. The following USOC jacks may be used with this equipment:
RJ11C.
3. The REN is used to determine the quantity of devices which
may be connected to the telephone line. Excessive RENs on
the telephone line may result in the devices not ringing in
response to a call. In most, but not all areas, the sum of the
RENs should not exceed five (5.0). To be certain of the
number of devices that may be connected to the line, as
determined by the total RENs, contact the local telephone
company. For products approved after July 23, 2001, the
REN for this product is part of the product identifier that has
the format US:AAAEQ##TXXXX. The digits represented by
## are the REN without a decimal point (e.g., 03 is a REN of
0.3). For earlier products, the REN is separately shown on
the label.
4. If the equipment, B4545 MFP, causes harm to the telephone
network, the telephone company will notify you in advance
that temporary discontinuance of service may be required.
But if advance notice isn’t practical, the telephone company
will notify the customer as soon as possible. Also, you will be
advised of your right to file a complaint with the FCC if you
believe it is necessary.
5. The telephone company may make changes in its facilities,
equipment, operations, or procedures that could affect the
operation of the equipment. If this happens, the telephone
company will provide advance notice in order for you to
make the necessary modifications to maintain uninterrupted
service.
6. If trouble is experienced with this equipment (B4545 MFP),
please contact the following for repair and/or warranty
information:
Oki Data Americas, Inc.
2000 Bishops Gate Blvd.
Mount Laurel, N.J. 08054-4620
Telephone:(856) 235-2600 or
(800)-OKIDATA (800-654-3282)
If the trouble is causing harm to the telephone network, the
telephone company may request that you remove the
equipment from the network until the problem is resolved.
7. This equipment contains no user serviceable parts. Please
contact Oki Data for service.
8. This equipment cannot be used on public coin service
provided by the telephone company. Connection to Party
Line Service is subject to state tariffs. Contact your state
Public Utility Commission, Public Service Commission, or
Corporate Commission for information.
9. If your home has specially wired alarm equipment connected
to the telephone line, ensure the installation of this B4545
MFP does not disable your alarm equipment. If you have
questions about what will disable alarm equipment, consult
your telephone company or a qualified installer.
Equipment With FAX Capability
The Telephone Consumer Protection Act of 1991 makes it
unlawful for any person to use a computer or other electronic
device, to send any message unless such message clearly
contains in a margin at the top or bottom of each transmitted
page or on the first page of the transmission, the date and time
it is sent and an identification of the business or other entity, or
other individual sending the message, and the telephone
number of the sending machine or such business, other entity,
or individual. (The telehone number provided may not be a 900
number or any other number for which charges exceed local or
long-distance transmission charges.)
In order to program this information into your FAX machine,
you should complete the following steps:
• Date and time: see “Changing the Date and Time” under
Setting Your Terminal in the User’s Guide for instructions on
doing this.
• Name and telephone number which identify the source of
your fax transmission: see Your fax number/your name under
Setting Your Terminal in the User’s Guide for instructions on
doing this.
These requirements apply to all FAX machines, and have been
extended to all FAX modems manufactured on or after
December 13, 1995.
FCC Radio Frequency Interference Statement for
120-Volt Models
WARNING: This equipment has been tested and found to
comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try
