•••• www.ojedausa.com • [email protected] • Pg. 4 ••••
MOVING THE EQUIPMENT
Disconnect the power cord plug from the wall outlet. Remove product, then defrost, and clean the
freezer. Secure all loose items such as shelves and fix the door
by taping it securely in place to prevent
damage. In the moving vehicle, secure the freezer in an upright position and cover it to protect the
outside of the cabinet.
PLACING AND INSTALLING THE EQUIPMENT
T
HIS UNIT CANNOT BE INSTALLED IN ENVIRONMENTS WITH EXPLOSIVE GASES
.
T
HE EQUIPMENT IS
DESIGNED ONLY FOR INDOOR OPERATION
.
The unit must be located in an indoor environment.
For the correct performance of the refrigerating system, it is very important to
leave at least 10 cm (4")
of free space both at the sides and back
to allow proper air circulation. Do not block the grills on the
back of the cabinet.
ENERGY SAVINGS IDEAS
The location of the cooler must be
kept away from sources of heat and humidity
including direct
sunlight, toasters, ovens, coffee warmers, other appliances condenser air discharge, infrared heaters, or
other heat generating appliances.
Overloading the freezer forces the compressor to run longer. Do not exceed the load limit according to
labels fixed on the inner cabinet.
Product to be loaded should be at -4° F (-20° C) since the equipment is intended for maintaining a cool
product at 0° F (-18° C) at load level rather than freezing a warm product
Keep the lids closed to avoid warm air and moisture getting into the freezer.