Oilon OilonCooling Ck5, Installation And Operation Manual

Page: 10 / 29

Pipe connections, Ck9
Pos. Item
1 Bleed valve
2 Brine out, 3/4"
3 Brine in, 3/4"
4 Condensate drain
Condensate tray installation
The condensate tray ensures that any condensate from pipe joints is led back into the
unit, preventing moisture damage to any surrounding structures.
1. Remove plastic plugs.
2. Install the condensate tray as shown in the image.
A: insulation
3. Insulate the condensate tray.
Condensate drain installation
● To prevent air pockets, cut the condensate drain as short as possible and use a
downward slope (min: 2%).
● Minimum water seal depth: 50 mm.
● The highest point in the condensate drain must not be higher than 200 mm from the
top of the cooling unit.
● Carefully insulate the condensate drain pipe.
● If there are several cooling units in the room, you can chain the condensate drain
pipes as shown in the image.
2.3 Electrical installation
To access the control unit, remove the grille and the metal cover plate as shown in the
image. Make the electrical connections according to the electrical diagrams.
8 (20) M8015 2337EN