Oilon Lampoassa RE 28-48, Installation And Operation Manual

Page: 30 / 78

When using factory settings, the heating circuits have
Automatic
mode enabled, and
the time program keeps
Comfort
mode on permanently. If a time program is used
to switch from Comfort mode to Reduced mode, Comfort mode can be temporarily
restored by selecting a temporary operating mode for the heater (from the Temporary
setting). The heating circuit’s operating mode will return to normal the next time
the time program changes the mode or the user some other operating mode than
Automatic
.
Settings
Automatic mode. Heating circuits
should be kept in
Automatic
mode.
Comfort
setpoint for room
temperature always on.
When the operating mode is set to
Comfort
, the setpoint for the room
temperature in Comfort mode can
be changed.
The
Reduced
setpoint for room
temperature.
Time programs are enabled in
Automatic
mode only.
Temporary comfort mode selected
for the heating circuit.
5.5 Heating curve
You can adjust the slope of the heating curve in the settings menu. The change applies
only to the heating circuit assigned to the relevant user interface. Use the parameter
list to change other settings for the particular heating circuit (and the settings of other
heating circuits connected to the system).
1. Select
Settings
. 2. Move to the correct menu page. 3. Enter the desired heating curve
slope.
28 (74) M8009 2147EN