OHAUS Frontier FC5714, Service Manual, Page: 18 / 43

18 SERVICE MENU
• By pressing the key rpm/rcf the display „rpm/rcf“ is activated and now you
can scroll through the error list either with the potentiometer.
• Now the 99 last occurred error messages are indicated either by turning the
potentiometer, whereas the first two numbers do describe the place number
and the last two numbers do describe the occurred error.
• According to the software status, individual error messages may not be
indicated resp. may have slight deviations.
•
ATTENTION : In case that the signal generator is switch off, the keypad tone
and the audible error message will also be suppressed.
The audible error message is automatically activated if the signal generator
has been switch on
The following table gives information on the individual error messages:
2.1.7 Submenu Setup of the signal generator
Here you can switch on resp. switch off the signal generator (audible sound).
• Activate the operation menu as described under „Activation of the operation
menu (Part 1)”.
• Turn the potentiometer, until the special digit „L“ appears in the service
display.
• By pressing the key rpm/rcf the display „rpm/rcf“ is now activated and you
can setup the respective option with the potentiometer.
• Now the audible sound is activated resp. not activated by the end of the run
or when an error message will occur.
Attention : In case that the signal generator is switch off, the keypad tone and
the audible error message will also be suppressed.
The keypad tone has to be switched on again after the reactivation of the
signal generator.
However the audible error message is automatically activated if the signal
generator has been reactivated.
Attention : After all points have been reviewed and/or set up, you have to
press shortly the key start to store all parameters. Otherwise the setups were
all for nothing. If the storage has been successful in the display „rpm/rcf“ the
value of the imbalance sensor and the word „StorE“ are indicated.