Quick Start Guide
CL Series Scales
Ohaus Corporation www.ohaus.com
i
CL Series Scales
Quick Start Guide
PREPARATION FOR USE
Release Locks
Before using the scale, release the
Transportation Lock. On scale bottom,
slide the locking pin to the position.
Check Power
Ensure voltage identification label matches
local line voltage. If not, do not connect the
unit. Contact Ohaus or your dealer.
To use battery power, remove battery cover
and insert three LR6 (AA) batteries.
Allow at least 30-60 seconds warm-up time,
for scale to stabilize before operation.
SELECTING THE LOCATION:
Place on a firm, steady surface with sufficient space.
Avoid excessive air current, vibrations, heat sources, or rapid temperature changes.
SAFETY PRECAUTIONS
For dependable operation of this product, observe the following precautions:
•
Verify that the input voltage printed on the power Adapter and the plug type
matches the local power supply (if using AC power).
•
Make sure that the power cord does not pose an obstacle or tripping hazard.
•
Disconnect the product from the power supply when cleaning.
•
Do not operate this product in hazardous or unstable environments.
•
Do not drop loads on the pan.
•
Use only approved accessories and peripherals, as available.
•
Operate the product only under ambient conditions specified in the Instruction
Manual.
•
Service should be performed by authorized personnel only.
Transportation
Lock
Power Input Jack
Remove
Battery
Cover to
insert 3
Batteries:
LR6 (AA).
