OFITE, 11302 Steeplecrest Dr., Houston, TX 77065 USA / Tel: 832-320-7300 / Fax: 713-880-9886 / www.ofite.com
10
In software mode, the test is run with the device connected to the PC.
1. Ensure the mud sample is homogenous. Mix the sample thoroughly using
a blender if necessary. Ensure there are no air bubbles in the sample be
-
fore inserting the probe. Immerse the probe so that the slots in the probe
shield are submerged.
2. Power on the device using the power button.
3. Attach the probe to the MudChecker device. Then insert the probe into
your drilling fluid sample.
4. Click the “Run” button to initiate testing.
5.
The software will prompt you to insert the device probe into the drilling
fluid and then click “OK” to start the test. Click “Cancel” to start over.
6. Once testing is completed, the software displays a confirmation message.
The user then has the option to discard the test results or save the test
results into the Test Archive.
Testing
With Software
