Office Star Products Space 39006, Operating Instructions

Page: 1 / 2

4
4
STEP 1 STEP 2 STEP 3
STEP 4 STEP 5 STEP 6
39006 FAUTEUIL DE TRAVAIL EN CUIR AVEC APPUIE-TÊTE
INSTRUCTIONS DE MONTAGE
39006 EXECUTIVE LEATHER CHAIR WITH HEADREST
OPERATING INSTRUCTIONS
© Office Star Products May 2004
Enlever toutes les pièces du carton, les organiser selon les numéros de pièce indiqués sur la liste et s’assurer
que les quantités des pièces reçues sont correctes.
ÉTAPE 1
Insérer les roulettes (2) dans la base (1). S’assurer que toutes les roulettes (2) sont verrouillées en place.
Placer la base (1) à la verticale de façon à ce que les roulettes (2) soient par terre.
ÉTAPE 2 Attacher les bras (9L et 9R) à l’assemblage du dossier (6) en utilisant quatre longues vis Allen (7).
RESSERRER COMPLÈTEMENT TOUTES LES VIS.
ÉTAPE 3
Attacher le plateau du siège (4) à l’assemblage du siège (5) en utilisant quatre vis moyennes (9)
RESSERRER COMPLÈTEMENT TOUTES LES VIS.
ÉTAPE 4
Insérer l’assemblage du dossier entre le siège relié (5) au plateau du siège (4). Les attacher en utilisant
trois courtes vis Allen (8). RESSERRER COMPLÈTEMENT TOUTES LES VIS.
ÉTAPE 5 Insérer le vérin pneumatique (3) dans la base (1). Placer le siège assemblé sur le dessus du vérin
pneumatique (3). Appliquer de la pression pour verrouiller le siège.
ATTENTION : AVANT D’UTILISER LE FAUTEUIL, S’ASSURER D’AVOIR RESSERRÉ COMPLÈTEMENT
TOUTES
LES VIS.
PIÈCE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . QTÉ
1. BASE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1
2. ROULETTE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5
3. VÉRIN PNEUMATIQUE . . . . . . . . . . . . . . . . . . . .1
4. PLATEAU DU SIÈGE . . . . . . . . . . . . . . . . . . . . . . .1
5. ASSEMBLAGE DU SIÈGE . . . . . . . . . . . . . . . . . .1
6. ASSEMBLAGE DU DOSSIER . . . . . . . . . . . . . . . .1
7. VIS ALLEN LONGUE . . . . . . . . . . . . . . . . . . . . . .4
8. VIS ALLEN COURTE . . . . . . . . . . . . . . . . . . . . . .3
9. VIS MOYENNE . . . . . . . . . . . . . . . . . . . . . . . . . . .4
10. BRAS (10L) ET (10R) . . . . . . . . . . . . . . . . . . . . .2
11. CLÉ ALLEN . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1
5
FEATURE
• PNEUMATIC SEAT HEIGHT ADJUSTMENT
To raise seat remove pressure from seat and pull lever (1)
up. To lower seat height sit on chair and pull lever (1) up.
• TILT LOCK
To lock, return chair to the upright position and push lever (1)
in. To unlock pull lever (1) out.
• TILT TENSION ADJUSTMENT
For individual comfort, this chair has been equipped with
an adjustment that will allow the user to change the tension
of the tilting feature. Turn knob (2) clockwise to increase
tension and counter-clockwise to decrease or ease the
tension.
NOTE: Be careful not to loosen back tilt adjustment knob
completely.
• HEADREST ADJUSTMENT
To adjust the height of the headrest loosen the adjustment
knob at the back of the headrest. Do not over loosen the
adjustment knob. Move the headrest to desired height and
tighten the adjustment knob.
WARNING
1. Use this product only one person at a time.
2. Do not use this chair unless all bolts screws and knobs are
securely tightened.
3. Check that all bolts screws and knobs are tight every six
months or as needed.
4. Do not overturn back tilt knob when decreasing tension.
5. Dispose of packing material properly. Do not use plastic
cover as head covering. It may cause suffocation.
6. Do not use chair as a stepladder.
7. Use this chair for its intended purpose only.
WARRANTY
Space and ProLine II chairs are warranted from the date of purchase against failure due to material and workmanship as follows:
• Lifetime on component Parts Including pneumatic cylinder, control mechanism, base and casters.
• 3 Years on upholstery fabric and foam against wear and deterioration.
• Leather is not warranted against routine scratching and scuffing, as leather is subject to minor blemishes in use.
All warranties are limited to the original purchaser for normal commercial usage defined as a standard forty hour work week by persons weighing 250 lbs. or
less. This warranty will not cover labor, freight or damage from misuse, abuse, negligence, alteration, accident, vandalism, rusting, acts of nature or any other
event beyond the control of Office Star Products. The warranty does not cover cosmetic damage that may result from normal use. Liability for incidental or
consequential damages is excluded to the extent permitted by law. The user assumes all risk of injury resulting from use of this product. When usage is more
than 40 hours per week, a five year warranty on all parts applies. Fabric is warranted for one year.
TO MAKE A WARRANTy CLAIM
Contact Parts Department. Provide model number and description of the problem and obtain confirmation number. At its option,
Office Star Products will:
a. Supply compatible components of current manufacture.
b. Repair the customer’s component.
It is the customer’s responsibility to prepay freight on any components returned to the factory. Return freight on components
covered by warranty will be paid by Office Star Products.
Our quality standards are among the highest in the industry. Sometimes, no matter how hard we try, there are times when parts are damaged or missing. Our
customer Parts Department will do everything possible to promptly remedy the problem.
Contact us via email parts@officestar.net , by Fax 1-909-930-
5629, or toll free parts number 1-800-950-7262, Monday through Friday 8:00 a.m. - 5:00 p.m. Pacific Time.
1
2
4
9
5
6
10R
10L
7
11
11
6
8
5
3
3
5
6
1
4