English 9 English
Output Connections
Refer to points [7], [8] and [9] of the Figures below.
Controls and Operational Features
1. LED Indicator Power switch (only
CITOMIG 185MP
):
This LED lights up when the welding machine is ON
and is ready to work.
3
6
1
2
4
5
7
8
9
Figure 1.
2. Thermal Overload Indicator: It indicates that the
machine is overloaded or that the cooling is not
sufficient. Depending on:
CITOMIG 185MP
: Overload or
insufficient is shown by lighting LED
under the symbol.
CITOMIG 210MP
: The message as
image is shown by the display [13].
3. Process Welding’s Switch:
GMAW (MIG/MAG) process
Warning:
Can be used to FCAW-SS
process.
SMAW (MMA) process
WARNING
When the machine is switched again on, last welding
process will be recalled.
WARNING
If the push-button is pushed in GMAW process in, the
output terminals will lived.
WARNING
During SMAW process, the output terminals are still lived.
4. Knob Control: Depending on welding process, this
knob controls:
GMAW
process
Inductance: Arc control is
controlled by this knob. If the
value is higher, the arc will be
softer and during welding is
less spatters.
SMAW
process
ARC FORCE: The output
current is temporarily
increased to clear short circuit
connections between the
electrode and the workpiece.
5. WFS/Hot Start Control: Depending on welding
process, this knob controls:
GMAW
process
Wire feed speed WFS: Value
in percentage of nominal value
wire feed speed.
SMAW
process
HOT START: Value in
percentage of nominal value
welding current during arc start
current. The control is used to
set the level of the increased
current and arc start current is
made easy.
6. Welding Load Voltage / Current Knob Control:
Depending on welding process, this knob controls:
GMAW
process
The welding load voltage and
set by this knob [6] (also during
welding).
SMAW
process
The welding current is set by
this knob [6] (also during
welding).
7. EURO Socket: For connecting a welding gun (for
GMAW / FCAW-SS process).
8. Positive Output Socket for the Welding Circuit:
For connecting an electrode holder with lead /
work lead.
9. Negative Output Socket for the Welding
Circuit: For connecting an electrode holder
with lead / work lead.
10. Left Knob: The value of parameter in the upper left
side of display [13] is adjusted.
11. Right Knob: The value of parameter in the upper right
side of display [13] is adjusted.
12. Set Knob: Type of welding procedure and welding
settings is changed by this knob.
13. Display: Parameters of welding process are shown.
14. User Button (left): Button function could be set:
Advanced
menu:
Recalls advanced menu (default)
Recalls user memory.
Inductance.
Run-in
WFS.
Burnback.
Basic menu – changes basic menu for advanced
menu.
