background image

Rear View of Speaker Assembly 

Installation of 15° Angled LCRS Ceiling Speakers 

 

1.  Check ceiling area for concealed obstructions such as wiring, plumbing, heating ducts, etc. 

2.  Use a “stud finder” to locate positions of joists or rafters.  Make sure that your intended locations for your 

speakers are unobstructed and that the holes will be at least 1 inch away from joists or rafters. 

3.  Use the supplied compass or cut-out template/paint mask to draw a circle with the diameter that corresponds 

to the model of your speaker on the chart below, and carefully cut out the hole. 

4.  Remove the grille from the speaker assembly using the included grille remover tool. 

5.  Before installation, turn the “Angle Lug Installation Clamps” (Item A) so they are positioned as in the image 

below.  This way, they will clear the cut-out hole for installation. 

6.  Prior to inserting the speaker assembly into the cut-out hole, attach speaker wires.  Make sure to observe 

polarity (the “+” and the “-”).  Speakers wired 

out of phase

 will exhibit an apparent loss of bass response.  

The wires will be held in place by the “Spring Clip Terminals” (Item B).  Wires should be stripped about 1/2".   

7.  Insert the speaker assembly into the hole and orient it so that it is angled toward the listening area.  A clear 

plastic template is included to precisely align the direction of the speaker.  The template must be removed 
before the speaker is operated. 

8.  Begin to tighten installation screws.  As you start to turn each screw, the “Angle Lug Clamps” will rotate 

outward to engage ceiling material (Item C).  

CAUTION:

  DO NOT OVER-TIGHTEN THE CLAMPS.  Too 

much torque may snap off the lug, causing the speaker not to seat securely.  A snug fit is all that is necessary 
to assure proper performance. 

9.  If speaker assemblies are to be painted, either before or after installation, use the paint masking template 

(cardboard disc) to cover the speaker driver(s) to prevent damage.  DO NOT TRY TO PAINT THE GRILLE 
AND FRAME  
ASSEMBLY TOGETHER.  The grille should always be painted separately.  Use thin coats taking care not to 
block perforations with excessive paint. 

10.  Your speaker includes a pivoting tweeter and it may be aimed to achieve even better imaging.  Tweeter 

output should be directed toward the typical listening position.  

USE CARE TO AVOID DAMAGING THE 

DOME OF THE TWEETER DURING AIMING!!

 

Models 

Mounting 

Diameter 

PS-615 LCRS 

9 1/4" 

PS-815 LCRS 

11 1/2" 

Mounting 

Depth 

5" 

5 3/4" 

OEM Systems Company, Inc. 

www.oemsystems.com 

Reviews: