4 Safety In
s
truction
s
Instruction Manual Corvis® ST (G/72100/XXXX/EN 1019 Rev01)
5 / 80
4.2
Safety In
s
truction
s
for U
s
e
Attention
Personal or property damage due to false operation
Comply with the following safety instructions.
Personal or property damage due to unsafe equipment modifications
No modifications may be made to this device without the permission
of the manufacturer.
Information for the operators
Make sure that the Corvis® ST is used only by clinical persons or eye
spacialists
who can guarantee proper handling due to their knowledge,
training and practical experience.
who have been instructed by OCULUS staff or an authorized de-
aler before the initial operation.
Transport and Storage Instructions
Refer to the notes in
.
Information for set-up and connection
Do not use the Corvis® ST outdoors or in damp rooms, and do not
store the device there.
Keep the Corvis® ST away from water that may drip, splash or spray
on it, and make sure that no liquids can enter the Corvis® ST. Do not
place any containers holding liquids in the vicinity of the Corvis® ST.
Germany: Only operate the Corvis® ST in rooms used for medical
purposes if VDE 0107 installation procedures have been observed.
Do not operate the devices included in the delivery in areas where
explosions may occur, or in proximity to flammable anesthetics or
volatile substances such as alcohol, benzine or similar products.
Only use a power cord which meets the requirements of the
standards IEC 60227-1, Type H03VVH2-F, min. 0,75 m² and IEC
60320-1, Type C7.
Set up the Corvis® ST so that the power plug is easy to access. That
way, you can easily disconnect it from the power supply for any
repairs or maintenance work.