Octave V 110 SE, Owner'S Manual

Page: 33 / 38

34
12. SPECIFICATIONS AND DIMENSIONS
Output Configuration: Push Pull, advanced Pentode Mode, Grid 2 Voltage 340 V, Idle Current
Tubes 28 mA - BIAS Low, 34 mA - BIAS High. Negative Grid Voltage separately adjustable for
each Tube. Range: -16 to -45 V, 3 turn precision regulators.
Wideband Output Transformers using Silicon steel PMX Core, single Impedance Output.
Optimum Load Impedance 3 - 16 ohms Nominal Speaker Impedance. Efficiency greater than 83
dBs Amplifier remains stable with No Load and Output short-circuited.
In- and Outputs
Inputs
6 x Cinch (including one HT Bypass input)
An RCA input can be assigned to the optional
phono MM or MC
1 x XLR
Ausgänge
1 x Regulated Preamplifier Output RCA
1 x RCA Record Output
1 x Loudspeaker Output
XLR Pin Belegung 1 = ground, 2 = plus, 3 = minus
Output stage
Output Power into 4 ohms Power Selector High 2 x 110W RMS
Power Selector Low 2 x 70W RMS
Peak Power into 4 ohms
Power Selector High 2 x 130W Peak
Power Selector Low 2 x 90W Peak
Into 8-Ohms Load the Output Power is reduced
by 20 %
Frequency response
20Hz - 70kHz @ 90 W - 1 / - 3 dB
5Hz - 70kHz @ 10 W - 0 / - 2dB
THD / Distorsion factor 0.1% at 10W an 4 ohms
Signal-to-noise ratio -110 dB / 90 W
Output Noise < 200 µV
Optimal load impedance 3 – 16 ohms
Minimum load impedance 2 ohms
Overall gain LOW / MED / HIGH 34 dB / 37 dB / 38 dB
Damping factor LOW / MED / HIGH 5 / 7,2 / 10
Output tubes 4 x KT 120
Quiescent current; output tubes 28 mA - BIAS Low, 34 mA - BIAS High
Preliminary stage
Input Impedance 50 K ohms / Cinch, 25 K ohms / XLR
Input Sensitivity 270 mV Line Level Eingänge
Crosstalk input to input - 105 dB
Channel Separation
55 dB
Output Impedance Pre out 240 Ohm
Max. Level Pre Out 5 V RMS
Driver tubes LOW 1 x ECC 82, 2 x ECC 81
MED 1 x ECC 81, 2 x ECC 81
HIGH 1 x ECC 83, 2 x ECC 81