Octave TouchTunes MX-1, Installation Manual

Page: 13 / 84

Prepare to Install OS2 Upgrade Kits
Required Tools and Equipment
OS2 Upgrade Kit Installation Guide
7
2.1.3 Record Current Jukebox Settings
When upgrading your jukebox to OS2, your existing settings are not preserved. It is strongly recommended to record
all settings beforehand so that you can set them to these values after the upgrade which includes the hard drive
replacement.
2.2 Required Tools and Equipment
Accomplishing the procedures described in this section requires the use of the following tools and equipment:
• Screw drivers (slotted and Phillips head)
• Nut driver or hex-head screw driver, assorted sizes
• Cable ties for dressing cables
• Wire cutters
2.3 Estimated Time to Complete the Installation
The degree of complexity and time to complete the installation may vary slightly, depending upon the installer’s
experience and comfort level in working with electronic equipment and hardware.
A typical installation can usually be completed in approximately 45 minutes.
2.4 Unpacking and Checking OS2 Upgrade Kit Components
The TouchTunes Universal Computer and I/O Board Upgrade Kit (P/N 600305-001) for jukeboxes may be delivered
in several boxes and includes the following:
• Metal riser bracket pieces, mounting bracket for the computer and I/O Board, cables, screws, and this manual
• Computer (with green label)
• I/O Board
NOTE 1 The new computer (P/N 301090-001) is marked with a green label to indicate it is “universal”. If
the P/N and label of the computer you receive does not match, then you have not received the
correct model.
NOTE 2 The hard drive for the new computer is shipped separately. Make sure you have received the
hard drive before proceeding with installation. If the hard drive has not yet arrived at your
location, contact TouchTunes.
NOTE 3 The TouchTunes Power Supply Unit Upgrade Kit (P/N 600306-001) is ONLY required for
jukeboxes equipped with an MJS computer. This includes those currently running an MJS, as
well as those which have previously been upgraded using a “JCB
+ for MJS Upgrade”.
Jukeboxes which have only ever had a JCB or JCB + for JCB computer DO NOT REQUIRE
these additional parts (for example, an MX-1 jukebox).