Octave TouchTunes Allegro, Installation Manual

Page: 70 / 84

OS2 Upgrade Kit Installation Guide
Install OS2 Upgrade Kits in Allegro
Installing New Components
64
4.2.4 Installing the Power Supply Unit Upgrade Kit (where applicable)
To complete the combined Computer-I/O Board-PSU mounting bracket installation on the jukebox, go to section
4.2.2 Installing the Universal Computer and I/O Board Upgrade Kit .
4.2.5 Installing the New Hard Drive
To install the hard drive:
1. Unlock and open the jukebox.
2. Ground yourself by touching an exposed piece of metal in the jukebox case.
3. Ensure that the computer is powered OFF at the switch on the power supply.
4. Locate the hard drive for OS2. The OS2 hard drive is contained in an enclosure. The hard drive and its enclosure
are shipped separately from the OS2 Upgrade Kits. If the hard drive has not yet arrived at your location, contact
TouchTunes.
5. Align the hard drive enclosure with its slot on the left-side under-panel of the computer. The hard drive enclosure
cannot be inserted in its slot until it is properly aligned.
6. Insert the hard drive enclosure into the slot and then gently push the enclosure in until it is completely seated.
7. Using your fingers, push in and then tighten the thumb screw (clockwise) on the hard drive tray until the thumb
screw is securely tightened.
8. Test whether the hard drive is firmly seated by pulling out firmly on the handle of the hard drive tray. The hard
drive is secured properly when:
•
The thumb screw is completely compressed and covered by the cowl head of the thumbs screw, that is, the
spring is not visible.
• There is no gap between the edge of the hard drive tray and the computer.
• There is no play between the hard drive and the computer when you pull outward on the handle of the hard
drive tray. If you detect any play in the hard drive tray, using a slot-head screwdriver, tighten the thumb screw
firmly into the computer and test again until no play is detected.
NOTE The new computer uses a SATA hard drive with a red tray. Do not attempt to swap the hard
drive with an IDE drive from another TouchTunes jukebox model, as you can damage the
jukebox.
CAUTION: Using a screwdriver applies significantly more torque than
hand-tightening. Do not over-tighten.
WARNING: Do not, under any circumstances, attempt to force the wrong type of hard
drive into the HD slot of the OS2 computer. By doing so, you risk serious damage to
the hard drive and the computer.