41
3.
Installation
3.1
Dish Setting
Select the satellite/antenna and LNB settings for service search.
The values that are set in this menu will be available for selection
in other service searching menus.
Satellite : Select the satellite which you want to do a search
for.
-
Press the LEFT/RIGHT ARROW button to select the satellite.
-
If you press the OK button, the entire satellite list will be
displayed.
-
Select the desired satellite name to search.
-
If the desired satellite name is not listed then select User
Defined.
Tuner Connection : You can set connection type between Tuner and LNB.
-
Separate :
Set the connection type option to ‘
Separate
’, if each of the tuners are connected to
different LNBs (
LNB IN_1 / LNB IN_2
) individually / independently.
This Separate connection is used, when each two tuners are connected to different LNBs. Due the
independent & separate connections between two Tuners & LNBs, user can watch all the services
scanned by one tuner(1), while the other tuner(2) is set for recording at the same time.
-
Loop-Through :
Set the connection type option to ‘
Loop-Through’
, if you have connected the
LNB
OUT_1
and
LNB IN_2
with a loop-through cable. In this case, you would have some limitations in
using some features such as dual recording.
This connection is used when the Tuner(1) is connected with LNB output, and the Loop-through
output of the Tuner(1) is connected with input of the Tuner(2). This is the way to use & activate both
tuners when you have only 1 LNB with your dish antenna. However, this will limit the possible
tuning range (Satellite & Polarization) of the 2
nd
tuner, while the 1
st
tuner is being used for its
recording process (because the input signal of 2
nd
tuner is dependent of the signal which the 1
st
tuner is tuned to).
NOTE : User should make the appropriate connection by choosing the right tuner connections
between the Loop-Through and Separate connections. Due to the difference of these
two connections, wrong LNB and Tuner connection may cause the loss of signal reception.
We strongly recommend the use of professional service personnel to make this installation
and connection if your knowledge is limited.
Tuner : Select the tuner which you want to set (
Tuner 1/ Tuner 2
). If you set ‘
Loop-Through’
on the
menu(
Installation-Dish Setting-Tuner Connection
), this menu(Tuner) will be disabled automatically.
Frequency : Select the satellite frequency which you want to use for checking the signal.
LNB Power : Select the LNB power on or off.
LNB Type : Select the LNB type.
LNB Frequency : Select the local oscillator (L.O.). frequency that is specified for the LNB used..
-
Use the LEFT/RIGHT ARROW buttons to select the LNB frequency.
-
If the required LNB frequency is not listed, then enter the frequency manually using the NUMERIC
buttons.
-
When you select Universal LNB type, both 9750 and 10600 are supported at the same time. And
then the LNB 22KHz setting is disabled.
LNB 22KHz : When you use a separate coax 22 KHz tone switch box, make the 22 KHz tone switch
enabled or disabled to select the input you desire of the tone switch.
DiSEqC Switch : If you use
DiSEqC 1.0
or
DiSEqC 1.1
switch, select one of the DiSEqC inputs.
Service Search : Press the OK button to move to the Search Menu
