Connecting a monitor and keyboard
Figure 2–5 shows the XE–700 SBC with a monitor and keyboard. The following
sections describe how to connect these items.
WARNING!
The video connector on the XE–700 is keyed, but some cables are not
keyed and can be plugged in incorrectly. Ensure that pin 1 of the
cable is connected to pin 1 of the connector (indicated by the dot).
Incorrect connection could damage your equipment.
Figure 2–5
Connecting a monitor and keyboard
PS/2 Keyboard
VGA Monitor
2 mm VGA-12 cable
Dot indicates
pin 1
XE–700
Power Supply
PS/2 Keyboard Mouse
Cable
.
Monitor
The XE–700 SBC interfaces to a standard SVGA monitor through the J3 connector
using a 2 mm VGA-12 cable. Connect one end of the 2 mm VGA-12 cable into J3
and connect the other end to a SVGA monitor cable.
Note
The video switch, SW4 position 3, must be ON to use a monitor. This is the default
configuration.
26
