PLEASE READ INTRUCTIONS BEFORE INSTALLATION
Warning: Keep the reflector away from combustible materials.
Ensure your reflector is mounted securely and keep lamp cords away from
direct heat from both lamp and reflector. Light hangers or small chains are
good options to use for hanging the reflector.
Changing Lamps:
Let the reflector cool down and disconnect the power from the ballast when
replacing or changing out lamps. Use gloves to keep the lamp glass clean
from dirt and oils.
TO REMOVE A LAMP
•
Disconnect the power from the ballast
•
Remove holder cap [A]
•
Open the lamp holders by sliding them outwards, the lamp will be held in
place by a metal spring, however secure the lamp to prevent it from
falling out [B]
TO INSTALL A NEW LAMP
•
Make sure power is disconnected from the ballast
•
Confirm the lamp is clean, wear cotton gloves if possible
•
Confirm the end wires are straight
•
Remove holder cap [A]
•
Open lamp holders by sliding them outwards [B]
•
Install the lamp by gently pressing the lamp until the metal springs
hold the lamp [C]
•
Close the lamp holders by sliding them inward [D]
•
Important: Finally? Install the spring at the back of the Holder Cap and prevent
any loosening. [A]
•
Wipe the lamp with a clean soft cloth.
*Do not touch the reflective material with your bare hands
Copyright 2017
| All Rights Reserved
http://www.ocl-lighting.com
DOUBLE ENDED LAMP INSTALLATION
Note:
OCL recommends replacing the reflector after 5000 lighting hours.
Depending on the environment and contamination levels the reflector
will degrade.
The V53 Hammertone/Concave aluminum can not be cleaned without damage.
Therefore we recommend to changing the reflector once every year.
Also replace the lamp when replacing the reflector.
•
Switch off mains power.
•
Remove the lamp from the fixture.
•
Support the reflector on the side of the reflector lever to prevent it from falling.
•
Move the pin to the left.
•
Remove the reflector.
•
Place the new reflector. Ensure the reflector lever is in the opened position to
allow the reflector to pass.
•
Ensure the holes in the reflector are aligned with the pins in the fixture.
•
Release the reflector lever so its two pins hold the reflector in place.
•
Insert the lamp in the lamp holder.
•
Switch on mains power.
Copyright 2017
| All Rights Reserved
http://www.ocl-lighting.com
REPLACEMENT OF THE REFLECTOR