Ochsner TERRA 6, Operating And Installation Manual

Page: 41 / 92

INSTALLATION | Troubleshooting
982001-TERRA-M2-M4-EN04.1 | www.ochsner.com 41
12.2 Reset high limit safety cut-out
If the temperature sensor of the high limit safety cut-out
registers a heating water temperature of over 85°C, the
power supply to the internal electric booster heater is cut
off.
»
Check whether the high limit safety cut-out has
triggered.
»
Check the flow rate of the heating water.
»
Remedy the source of the fault.
»
Press the reset button on the rear of the appliance to
reset the high limit safety cut-out. The reset button
can be reached by hand from the left-hand side.
11_02_200_202_01_021
1
1 Reset button for high limit safety cut-out on rear of
appliance