Ochsner TERRA 6, Operating And Installation Manual

Page: 20 / 92

INSTALLATION | Appliance installation
20 www.ochsner.com | 982001-TERRA-M2-M4-EN04.1
11_02_200_214_01_002
Material damage
When being transported with the appliance cas-
ing disassembled, sensitive components will be
exposed.
»
Take care transporting the appliance.
10.1.2 Positioning the appliance
»
Position the appliance at the intended installation
location.
»
Use the pre-installed transport aids (2 lifting slings at
the front and 2 lifting handles at the rear) to slide and
tilt the appliance.
»
Observe minimum clearances.
»
Ensure the appliance is horizontal. To compen-
sate for minor unevenness in the floor, use the four
height-adjusting plastic glides on the underside of the
appliance.
i
Information
On the underside of the indoor unit, there are four
plastic glides with rubber mounted threaded pins
(without nuts). Discrepancies in floor height of up
to 6 mm can be compensated for.
11_02_200_214_01_003
1 2 3
1 Lifting sling
2 Mounting bolt
3 Appliance frame
»
After the appliance has been placed in position,
remove the two lifting slings at the front of the
appliance.
»
Undo and remove the two mounting bolts and remove
the two lifting slings.
»
Then screw the two mounting bolts back into the ap-
pliance frame.
10.1.3 Disassembling the appliance casing
11_02_200_214_01_006
»
Undo and remove the four knurled screws for the ap-
pliance casing panel at the rear of the appliance.
»
Undo and remove the two fixing screws for the control
box cover, on the rear of the appliance.
11_02_200_214_01_007
»
Slide back the control box cover. Lift the control box
cover up and away.