Ochsner TERRA 6, Operating And Installation Manual

Page: 13 / 92

INSTALLATION | Preparing to install the appliance
982001-TERRA-M2-M4-EN04.1 | www.ochsner.com 13
9. Preparing to install the
appliance
Before installing the indoor unit, preparatory work needs
to be carried out by qualified contractors.
9.1 Indoor unit installation location
Material damage
The indoor unit is intended to be installed only in-
side the building. It must not be installed in rooms
with high levels of humidity (permanently above
70%).
The installation location for the indoor unit must meet the
following requirements:
► A dry and frost-free room
► Sound optimised environment
► A horizontal floor with adequate load bearing ca -
pacity (for weight of indoor unit, see page 44,
Specification)
► Not situated directly below or above bedrooms
► Max. room temperature 30°C
► The installation room must not be subject to a risk of
explosions arising from dust, gases or vapours.
9.1.1 Keep minimum clearances
Observing the specified minimum clearances for the indoor
unit ensures:
► Correct installation of the appliance
► Fault-free operation
► Ability to carry out maintenance on the appliance.
11_05_200_214_01_001
C
D
B
A
E
A ≥ 1000 mm
B ≥ 500 mm
C ≥ 500 mm
D ≥ 50 mm
E ≥ 500 mm