Starting the gateway
OCEABridge User Guide
Page 14
User guide
2.2
Plugging in OCEABridge
1.
Insert the power adapter plug into the power port on the front of the device:
Figure 6 – Plugging in power cable
2.
Plug the power adapter into a wall outlet to turn on your gateway. When the device
is ready for us, the green light turns on and remains on. The system LED blinks during
OCEABridge startup.
The first step in configuration is to access the OCEABridge web application from your
computer using an Ethernet cable.
1.
Disconnect your computer from the regular network to avoid any IP address conflict
when connecting to OCEABridge.
2.
Plug one end of an Ethernet cable into the RJ-45 LAN port on the front of the
gateway. This port is only used to configure OCEABridge using the embedded web
Interface.
Figure 7 – Inserting the Ethernet cable into the LAN port
