SPORTS SERIES
Single / Dual / Colours / DMX
.
INSTALL & OPERATION MANUAL
19
Setting the default start up colour:
1. Once the configuration mode has been entered (see above). Toggling off the power and back on again quickly
(as in a normal mode change) will toggle between the default start-up colours (blue & white). This is indicated
by the colour displayed after the blue/white flash sequence.
2. To save the selected state simply turn off the light(s) when the required start up colour is displayed and wait
for 5-10 seconds.
3. The light(s) should now be configured to start with the selected colour as default.
4.4 SPORT MULTI COLOUR / COLOURS DMX - CONTROL WITH DC SWITCH OPERATION
NOTE: If mixing your underwater lighting system with Sport Multi Colour and Sport Colours DMX, then
operational and/or functional issues may occur, such as but not limited to, changing between modes and
Colour Cycle sync.
The Sport Multi Colour or Colours DMX has three modes of operation, single colour mode, strobe mode, and
cycle / programming mode:
1. Single colour mode
–
this mode is entered when the light is first turned on. The light will be a single colour, either
a default white, or a previously selected colour.
2. Strobe mode
–
to enter this mode, turn off the light for less than 1 second, then back on again. The light will flash
in a pseudo-random pattern - the colour will be the same as that in single colour mode.
3. Cycle / Program mode - to enter this mode toggle the power to the unit off twice for less than 1 second each
time. The light will then slowly cycle and fade through the colour spectrum (see diagram below for cycle order).
It can be left in cycling if required, or alternatively, once the light shows the desired colour this can be stored by
switching the light off for more than 2 seconds. When the light is switched back on it will be back in single colour
mode, displaying the previously selected colour.
Blue → White → Green → Blue → Red → Green
NOTE: If during the above operations, one or more lights connected go out of sync, simply switch off the
lights for more than 2 seconds, then re-enter cycle mode to re-select the colour.
NOTE: Cycle mode is not guaranteed to stay in sync between lights over time.
4.5 DMX CONTROL
Please refer to the purchased DMX Controller for details about how to use it. For 3
rd
party DMX control connection see
section 3.4.
Colour Change Fade Cycle Order
