SPORTS SERIES
Single / Dual / Colours / DMX
.
INSTALL & OPERATION MANUAL
17
3.5 FINALISING THE INSTALLATION
The SPORT Series lens is pre-coated with a specialized Tritonium® coating which makes the surface of the lens a non-
stick layer.
OceanLED does not recommend that bottom paint or any type of anti-fouling agent is applied to the light
body, as damage may occur due to chemical incompatibility. If bottom painting your lights, ensure the lens
and the white plastic retaining ring are free of any paint or residue. Please note that incorrect application will
invalidate your warranty.
3.6 TEST YOUR INSTALLATION
Always test the lights
BEFORE
the vessel goes back into the water. It is advised not to operate lights out of water for a period
longer than 5 minutes. Please make sure lights are fully cooled down before re-testing out of the water. Exceeding this may
cause damage to the light unit and invalidate your warranty. At this final stage make sure all of the system is operational. If
you have any issues, please contact your local OceanLED representative.
Never install a new light fixture then leave the vessel in the water unchecked for several days. When the
vessel is placed in the water, immediately check for leaks. Note that very small leaks may not be readily
observed. It is best not to leave the vessel in the water for more than 3 hours before checking it again. If there
is a small leak, there may be considerable bilge water accumulation after 24 hours. If a leak is observed, you
must TAKE ACTION IMMEDIATELY to prevent damage.
