EXPLORE
E6 & E7
.
2021 INSTALL & OPERATION MANUAL
5
3
Preparing the Hull
When installing an Explore unit, please ensure there is enough space on the inside of the vessel to remove
the insert for maintenance/after sales services. For example, the XFM unit requires an additional 100mm / 4”
from the rear of the mounting tube to allow the insert to be removed. (See overall dimensions below).
Ensure that the part of the light inside the vessel has a diameter of 100mm
/ 4” around it free from any
insulation material.
OceanLED recommends using a qualified installer / technician when making modifications to your vessel.
Please also consult the manufacturer for more detail on modifications and installation.
If lights are to be fitted to a conductive or wooden hull, an Isolation Kit must be used. Contact OceanLED for
additional details.
Depth/Spacing
Ideally mount your lights at similar depth levels to ensure matching colour consistency through the water. Deeper lights
will look duller and possibly differ in colour compared to shallower mounted units.
Spacing / Install Depth
E6/E7
Recommended Spacing
2.5-3m (8-
10’)
Recommended Installation depth (From the light waterline)
300mm (12
”)
Hole Cut Out
Hole Cut out size -
83mm (3.25”) / With Isolation Kit 89mm (3.5”)
Overall Dimensions
See overall dimension schematic
– See Appendix (Section 7)
