DISCOVER
D3
.
INSTALL & OPERATION MANUAL
3
1
Installation Checklist
1.
Decide on light spacing
– OceanLED recommendations available.
Though the Discover D3 has protection against temporary submersion from inside the boat, please
ensure the rear of the light is in a dry area and not subject to a wet environment, when installed.
2.
Ensure correct cable gauge is used (refer to relevant cable gauge chart).
3.
Preparing the hull. Ensure hull thickness is below the maximum 5
0mm (2”).
4.
Make sure the lights have been fitted following the correct orientation.
5.
Correct marine sealant applied evenly around bezel.
Ensure fully watertight seal is created after sealant cures.
6.
Correct fitting of light fixture onto hull. Never leave vessel unchecked for a few days after install.
Always check routinely for a few days after installation to ensure the install is correct and fully
sealed.
7.
Test installation BEFORE entering water. Never connect/ disconnect lights whilst powered ON.
8.
Troubleshooting if required - most issues can be resolved by following the guidelines.
