DISCOVER
D3
.
INSTALL & OPERATION MANUAL
7
Installation (Once hull preparation is complete)
1. Test light(s) before fitting.
2. Apply marine sealant to the rear of the front bezel to ensure a complete unbroken seal around the light.
1. Start feeding the light cable through the hole. Ensure the correct orientation of the light unit with the logo
facing upwards and mounting holes aligning with the pre-drilled pilot holes.
2. Insert the light into the hull, pressing the light hard into the hull and twist slightly to spread the sealant
around behind the light to ensure good adhesion.
Breakages due to lights falling out of the hull are NOT covered under warranty and can cause serious
bodily injury as can any falling object.
Marine Sealant
