MNL-1013 Rev B
1
Unpacking the HL-2000
1.
Unpack your lamp assembly carefully. Dropping this instrument can cause permanent damage.
2.
Inspect the outside of the instrument and make sure that there is no damage. Do not use the instrument if damage is present.
Contact your dealer for repair or replacement information, if necessary.
3.
Use this instrument in a clean laboratory environment.
Contents
Your HL-2000 package should contain the following:
•
HL-2000 Light Source
•
Power Cable
•
FHSA models only
o
One IC-DB15-2 interface cable for shutter operation
Setting Up the HL-2000 Light Source
1.
Plug the power supply into a wall outlet.
2.
Plug the other end of the power supply cable into the socket of HL-2000.
3.
Connect the SMA connector of your fiber optic cable to the SMA plugs.
4.
Turn the Halogen lamp on using the power switch on the rear of the HL-2000.
SMA Connector
Attenuator (FHSA
Models Only)
Summary of Contents for HL-2000-LL
Page 2: ......
