Oce WP28, Operation Manual

Page: 94 / 227

Interface
1-78
Network Interface Parameters
This section applies to the printers having the option network card
installed.
To make your printer supports TCP/IP, Netware, and EtherTalk networks,
you will need to install the option network interface card in the printer and
make the proper settings as explained in this section.
Using the operator panel, you can:
• Activate or deactivate TCP/IP, NetWare, and EtherTalk
• Activate or deactivate DHCP
• Enter IP address, subnet mask address, and default gateway address
To confirm or change network card parameters, proceed as follows:
1
Press the
MENU
key.
2
Press the or key repeatedly until
Interface >
appears. One of
the interface names shown below appears, indicating the current
interface.
Parallel
(default)
USB
Serial
(when a serial interface board kit is installed)
Option
(when a network interface card is installed)
3
Press the
ENTER
key. A blinking question mark (
?
) appears.
4
Press the or key repeatedly until
Option
appears.
5
Press the
ENTER
key again.
Option
Interface
? Parallel
Interface
? Option