Oce VarioPrint 6000 Plus Line, Maintenance Manual

Page: 40 / 102

Remove sheets from the process modules
Remove sheets from the interface module
Introduction
During the printing process, sheets can get stuck in one or more process modules. Sometimes,
you can only remove these sheets when the machine is off, for example when a sheet is stuck in
the preheat unit. Then, only trained operators are allowed to remove these sheets. This section
describes the procedure to check all the modules and remove the sheets.
Required tools
Service key (supplied with the machine)
Socket wrench 10 (supplied with the machine)
Heat-resistant gloves (supplied with the machine)
CAUTION
Certain parts of the machine may be hot. Therefore, always use the special heat- and oil-
resistant fuser gloves.
Procedure
1.
Open the front door of the interface module.
2.
Remove the sheets at B4.
B4
[38] Remove the sheets at B4
3. Close B4. Also push the rear side of B4 to close B4 completely.
4. Close the front door of the interface module.
NOTE
After you checked the interface module for sheets, you must press [Next] on the
operator panel to continue.
Remove sheets from the process modules
40 Chapter 3 - Maintenance tasks - Level 2
Océ VarioPrint 6000 line