Oce VarioPrint 6000 Plus Line, Maintenance Manual

Page: 14 / 102

Replace the cleaners
Open the doors and covers
Introduction
This procedure is only intended for key operators who received the special maintenance training.
When to do
If the maintenance icon in the dashboard indicates that maintenance is required soon or
immediately.
Before you begin
Make sure that you have 2 new spiral cleaners and 2 new sheet cleaners at hand.
Service key (supplied with the machine)
Socket wrench 10 (supplied with the machine)
Heat-resistant gloves (supplied with the machine)
Adhesive tape (supplied with the machine)
CAUTION
Certain parts of the machine may be hot. Therefore, always use the special heat- and oil-
resistant fuser gloves.
Procedure
1. Select the maintenance task from the list of the required and suggested maintenance tasks.
[System] view -> maintenance section -> press the [Start maintenance] button.
2. Press [Start] to start the maintenance wizard.
At the start of the procedure, the machine is turned off.
CAUTION
Wait until the machine is turned off. Opening the doors too soon can possibly cause
injury.
3.
Use socket wrench 10 to loosen the bolt of the front doors (2).
Replace the cleaners
14 Chapter 2 - Maintenance tasks - Level 1
Océ VarioPrint 6000 line