Oce VarioPrint 6000 MICR series, User Manual Operating Information

Page: 91 / 264

Punch or fold the output
Introduction
If your machine is equipped with the puncher/folder, you can finish your documents with
various binding methods. You have your documents punched for binders or fold them
from A3/Ledger or A3/Ledger-like media into A4/Letter documents. On the operator
panel you can indicate:
• The number of holes punched
• The folding method
Puncher
The number of holes you may punch depends on the puncher installed in your configu-
ration:
• 2 or 4 punch holes for A4/A3 media (primarily for markets outside the USA)
• 2 or 3 punch holes for Letter/Ledger media (primarily for USA market).
Note:
The two punchers listed above are not interchangeable. You can only replace the entire
puncher with the same type.
Folder
Folding methods available:
• Z-fold
• Half-fold.
Punch orientation
The punch orientation depends on how you place the media in the paper trays. The table
below gives an overview of the possible combinations and the resulting punch orientation.
Deposit header-up or left
#
Deposit header-up / left (Paper Logic)
Punch exam-
ple Feed edge Punch exam-
ple Feed edge Orientation
Short-edge
feed Long-edge
feed Portrait
Chapter 5 - Working with the operator panel 91
Punch or fold the output