Oce VarioPrint 6000 MICR series, User Manual Operating Information

Page: 78 / 264

Check the first set
Introduction
If you have a large print job and you want to check whether the job is printed correctly,
it is advised to check the first set before printing all other sets. When a job is sent to the
printer, the submitter can indicate in the job submission application that the first set
must be checked. However, the workflow profile that is selected on the operator panel
determines how the printer handles these requests.
Depending on the selected workflow profile, the 'Check first set' setting can have the
following values:
• 'On'
• 'Off'
• 'As in job'
When you use the 'Check first set' function, the printed set is subtracted from the indi-
cated total number of sets for a job. For example, when you need 10 sets, the printer will
print the first set and then stop. When you continue the job, the 9 remaining sets are
printed. This is different from printing a proof.
Methods to check the first set
You can use 1 of the following methods to indicate that you want to check the first set.
• Use a workflow profile where 'Check first set' is enabled. Then the printer stops after
the first set.
• Enable the function 'Check first set' in the 'Properties' window for a specific job only.
However, you can only change the 'Check first set' setting there when a workflow
profile is selected where the 'Check first set' setting is 'As in job'.
Note:
You cannot change this setting for the active print job .
How to enable the checking of the first set
1. Touch 'Jobs' -> 'Queues' -> 'Scheduled jobs' or 'Waiting jobs'.
2.
Touch the job you want to change.
3.
Touch 'Properties' - or touch the job 2x to open the 'Properties' window.
4.
Touch the 'Number of sets' button.
5. Touch 'Check first set' when the button states 'Off'.
Chapter 5 - Working with the operator panel 78
Check the first set