Oce VarioPrint 2045-65 NC, Job Manual

Page: 126 / 213

124 Océ VarioPrint 2045-65 NC Job Manual
Copying on special material inserted in the special feeder
1
Place and align the original face down in the automatic document feeder .
Follow the feed direction according to the dimensions and orientation of the
information on the original.
2
Insert the special material in the special feeder.
The face-down side is copied.
3
Select the 'Copy' mode .
The 'Basic' section automatically opens.
4
Activate the 'Paper' section.
Make sure that the 'Paper input' card is open.
5
Select 'Special feeder' .
6
Select the required size and orientation of the inserted material in the 'Size'
function box.
The upper icon provides non-standard sizes to select.
The enlargement or reduction is automatically adjusted and is displayed in the
'Basic' section.
[80] Select the special feeder and the size of the required material
[80] Select the special feeder and the size of the required material
7
Activate the 'Basic' section.
8
Select '1-sided' or '2-sided' in the 'Original' function box.
To copy 2-sided on the special material, feed the sheet into the special feeder
a second time.
Note:
The 'Staple' and 'Copy' functions are locked.
9
Select the number of copies.
10
Press the start key .
11
Close the special feeder.
Note:
You can use the platen to copy the originals on the special material.
Remember that the enlargement or reduction is not adjusted automatically (see
‘Make an enlarged or reduced copy’ on page 119).