Oce VarioPrint 2045-65 NC, Job Manual

Page: 114 / 213

112 Océ VarioPrint 2045-65 NC Job Manual
Common copy jobs
Copy one set of originals
Introduction
The automatic document feeder provides a rapid method to copy a set of copies
that is identical to the originals.
If you place the originals in the automatic document feeder, the Océ VarioPrint
2045-65 NC performs as follows:
■
Detects the dimensions and the feed direction of the originals.
■
Matches the detected information to the copy settings.
■
Selects the tray that holds paper of the correct size.
■
Shows the selected size, in the 'Paper' section.
If you use the platen to copy 5 x 8 or 11 x 17 originals, select the required
paper.
The Océ VarioPrint 2045-65 NC selects the tray that matches the required
paper size for the copies. If the paper orientation in this tray does not match the
feed direction of the originals, the Océ VarioPrint 2045-65 NC rotates the
image 90°. The rotation symbol
is shown in the 'Extra' section name box.
Press the start key , to begin your copy job.
Before you begin
■
The Key Operator can protect the access to the system, so that a credit card
or a PIN must be required to enter the 'Copy' mode (see ‘
Access the Océ
VarioPrint 2045-65 NC ’ on page 27 ).
■
Inspect your originals and make sure that all originals are standard. You can
use the automatic document feeder for those originals. If one or more
originals are non-standard, use the platen (see ‘
Prepare the copy job ’ on
page 98 ).
■
If the originals are different sizes and types, sort the set of originals into
separate job parts (see ‘
Prepare the copy job ’ on page 98 ).