Oce DFS10, Operator'S Manual

Page: 72 / 90

66 Technical data
Product specifications
The table below contains the product specifications for the DFS10.
Automatic operation The DFS10 is shipped with a Third Party Enablement Kit. The kit
enables the DFS10 to operate as an accessory to the host
machine. Each kit is for one host machine only. Additional host
machines require additional kits.
Binding speed Accepts approximately one copy set per 2 seconds
Book output time Approximately 2.0 minutes from the time of entrance of a copy set
into the DFS10 until the book is available in the Output Tray
Book capacity - On-line: 1 to 120 sheets
- Manual: 1 to 120 sheets
Output Tray capacity 20 to 80 books depending on the spine width
Cover Tray capacity - Cover Tray 1: 1 cover cassette (150 covers)
- Cover Tray 2: 1 cover cassette (150 covers)
Warm-up time - From the Off position: Approximately 2 minutes
- From the Energy Saver mode: Approximately 2 minutes
Electrical requirements - Standard office outlet
- Europe: 230 VAC, 50 HZ
- North America: 115 VAC, 60 HZ
Environmental requirements - Minimum: 17° C (63° F) at 15% relative humidity
- Maximum: 32° C (90° F) at 85% relative humidity
Machine dimensions - Height to paper bridge 1450 mm (59 inches)
- Height to Output Tray: 965 mm (38 inches)
- Height to top of Output Tray cover: 1200 mm (48 inches)
- Width: 597 mm (23 1/2 inches)
- Width with paper bridge retracted 1617 mm (63 2/3 inches)
- Width with paper bridge extended 2217 mm (87 1/4 inches)
Machine weight - Approximately 300 kg (660 lbs) with cassettes
Noise level - Run: 78 decibels
Power consumption - Warm up: 800 watts
- Operation: 324 watts
- Energy Saver: 31 watts
Heat output - Warm up: 2730 BTU per hour
- Operation: 1106 BTU per hour
- Energy Saver: 108 BTU per hour