Oce DFS10, Operator'S Manual

Page: 66 / 90

60 Problem solving
Problem-solving table
The table below lists some conditions that may occur during
the operation of the DFS10. You can resolve the problems
without calling for service by following the suggested
solutions in the table. For problems with the host machine
beyond the scope of this table, refer to the operator manual for
the host machine. For problems with the DFS10 beyond the
scope of this table, call for service.
Condition Causes Suggested solutions
DFS10 is not on. No power to the DFS10. Check that the DFS10 Power
Cord is connected to the
DFS10 and the wall
receptacle.
Check that the DFS10 Power
Switch is in the On
( I)
position.
Energy Saver indicator is
lit. The Energy Saver button has
been pressed to activate this
mode or the DFS10 has been
idle for the period of time
specified for this mode. Press the Energy Saver
button or send a job to exit
Energy Saver mode. Wait for
the DFS10 to warm up. See
chapter 4, ”Customizing your
DFS10”, for more information
about Energy Saver mode.
Lights are lit on the Mimic
Display of the DFS10
Control Panel. A jam has occurred in the
DFS10.
The indicated Cover Tray is
empty.
Clear the jam as directed in
the ”Locating and clearing a
jam” section of this chapter.
Load the Cover Tray as
directed in chapter 3,
”Making the books”.
Copy sheets do not feed. The Bridge is not on-line.
The Interface Cable is not
connected or is not connected
properly.
Move the Bridge to the left.
Connect the Interface Cable
to the DFS10 and the host
machine or check that the
Interface Cable is connected
properly.